Recent content by Beefcake

So I've finally come back to this after buying some ink, then finding out that another ink required replacement when I've gone to install it, then buying that ink, then finding another ink requires replacement... 4 separate purchases of ink later, I finally have all ink installed. I did the...

@The Hat , I'm unable to perform a clean. I have 4 ink tanks that are low, and as soon as I instigate a clean it pops up with the msg that 2 of the tanks needs to be replaced. I hold down the Resume button, but all that does is make the msg go away, it doesn't actually perform a clean...

Sadly it's going to have to be a phone photo, but it's clear enough to understand what I mean. I noticed it after a print I did that looked like it had banding in the sky. Did the checks, this came up. Cleaning hasn't done anything either, which I doubt it would, as interweb research points this...

@The Hat , turns out my printer head is fudged. Cyan print head alignment shows the top half faded, and the bottom half OK. Sitting on the fence whether or not printing is actually worth the large amounts of cash, or not. How hard is it to replace this print head, do you know?

@The Hat , I've been reading through your posts for the Pro-1 and I'm keen to save a few £'s by refilling the ink. However, I cannot seem to find the source of the ink that you choose for this printer? I noted your signature/footer, but Octoinkjet do not yet provide refills, and Precisioncolors...