Artur5's latest activity

There's the question of the nozzles too, Nifty. Those made from brass, copper or hardened steel may release small particles of different...

I don't follow you here.. Why do you think it's more difficult to feed filament in direct drive extruders ?. Have you tried?. I assure...

I guess that @Redbrickman wanted to sell you one of his "dozens" of Vorons..;) Good points about PLA. If your lamp has resisted for...

Good luck convincing @The Hat to replace his beloved PLA with another filament.. :p

I'd be very careful using anything 3D printed in direct contact with food/medicines. Even if PLA is often advertised as a health safe...

My five cents on what to expect from HT-PLA ( PLA-GF would a more accurate name ). As they say YMMV. Glass fiber filaments are VERY...

From own experience I agree with @Artur5. Buy a PFI-106M cart (130ml) to refill. PFI-1000M (80ml) would do also (no experience). Not...

Nice to hear that you have a brand new spare printhead. A wise move to get it when they were still available. 😃 Anyway if those BCI6...

Knowing Canon, I’d guessed beforehand that they discontinued the BCI6 inks years ago. It’s a surprise that they’re still manufacturing...

I’ve had my Pro 10 for seven years. After Canon’s original cartridges that came with the printer were empty I started to refill them...

I don't think it's a problem with the contacts. For one thing, it's very strange that only magenta has issues. There’re about 80...

If a brand new OEM cart gives the same results, then the problem isn't faulty ink or a damaged cart. It must be the printhead...

Ink starvation is more usual with sponge based carts, but the Pro10 cartridges have no proper sponge, only a thin felt pad at the ink...

For what I can see, there's no visible problem on this test. but I reckon that this photo isn't good enough for my ailing eyesight to...

I’m not saying anything against this particular filament, because I haven’t tried it, but in the past I had negative experiences with...