Artur5's latest activity

The long and winding road to 3Dland .. Voron for me, but I guess that one must be a bit nuts to choose this road, isn't so Redbrickman...

Your guess is as good as mine. An inside job ?. I'd say that, if it were so, Canon is rather sloppy protecting themselves from internal...

Three years ago I purchased from the same Ebay seller the service tool v5.306. It works fine on my Maxify. As PeterBJ says, for your...

That must be the only thing that they have in common..;)

I wouldn't bet on that, Maxifys are totally different printers from Canon Pro series. They have only the brand name in common. Besides...

I wouldn't use TPU for heat resistance. It's on a par or worse than PLA.

Nice design ! If I had to print this part, I'd choose a filament slightly flexible and with good outdoors endurance like PETG or ASA...

I put new handlebars on my bike. They aren't as wide as previous, so I'm out of space to mount my gear, except for the "thicker" bar...

Mine too, but I confess printing only the plastic parts and reusing the steel springs from broken pegs purchased at the store. :rolleyes:

I think "Permanent Chip" could also mean that the chip doesn't count down, it constantly shows full. These chips are intended for use...

I wonder if that applies not only to @The Hat but to all of us.. For instance, I plead guilty of printing clothes pegs for hours at a...

Maybe that is why you you are off your rocker, has it made you even more crazy than you used to be? :lol::weee:hide

ARC and permanent chips mean the same,. Once the ink level reaches empty, after the printer is switched off/on, ink level resets to full...

Take good care of your printers. In a few years, they will be the last survivors of the Bowden extruder species. People will pay a lot...

You seem to be on the opposite side of the counter, if you know what I mean :p Come on @The Hat, you know well that we're not talking...