videobruce
Printer Guru
- Joined
- Nov 8, 2006
- Messages
- 170
- Reaction score
- 21
- Points
- 148
- Location
- New York State
- Printer Model
- Canon IP4300 & Panny KX-MB271
This error that I never experienced or heard of before (until now). Out of no where when I was going to print this error showed.
The cyan cart was low at the time, I was going to print a single page, but this occurred.
I read a number of posts elsewhere and two much older here stating it's the;
1. printhead (including cleaning),
2. logic board,
3, replace both (which isn't going to happen),
3. power supply (including unplugging it for 10 min.),
4. all of the above.
Problem is, the carriage will not move, it's locked in the park position.
I have unplugged the PS, left it off for a few minutes, but no change. I tried to enter the service mode, but all I get is the 10x flashing green-orange.
The SM states to replace the printhead (what else is new), but not if I can't get the carriage to move. This is surely not easy to dissemble.
The cyan cart was low at the time, I was going to print a single page, but this occurred.
I read a number of posts elsewhere and two much older here stating it's the;
1. printhead (including cleaning),
2. logic board,
3, replace both (which isn't going to happen),
3. power supply (including unplugging it for 10 min.),
4. all of the above.
Problem is, the carriage will not move, it's locked in the park position.
I have unplugged the PS, left it off for a few minutes, but no change. I tried to enter the service mode, but all I get is the 10x flashing green-orange.
The SM states to replace the printhead (what else is new), but not if I can't get the carriage to move. This is surely not easy to dissemble.
Last edited: