Artur5
Printer Master
- Joined
- Jan 24, 2011
- Messages
- 1,298
- Reaction score
- 1,624
- Points
- 278
- Location
- Kmt. 0.
- Printer Model
- MB5150,Pro10s,i3Mk3s+,Voron2.4
I don't know about @stratman, but you certainly confused me.Straight from CURA.. Layer thickness .3mm.. Shell thickness .3mm..Layer height .3mm..
Fill Density on the old lamp was 90% and 35% 0n Johnny 5..
This will confuse the hell out of @stratman...
First of all, my slicer isn't Cura, I always use Prusa Slicer and probably those programs use different terms but, isn't layer height the same as layer thickness ? or do you mean horizontal width of the layer?.
Shell thickness = thickness of vertical walls or thickness of top and bottom walls ?
Did I succeed in feckin' confusing you ?
P.S:
90% of infill on the old lamp !!. No wonder you purchased filament by truckloads.
Last edited: