Hy Folks
Just a quick update .
I have now cleaned the heads replaced the ink with fresh ink from octinkjet
Removed and re loaded all the software
and also allowed the printer to manage the settings .
Prints are now fine and back to Normal .
Not totally sure what actually cured the problem...
Thank you Gentlemen I have read carefully all your comments and make the following observations in reply .
1.I have had good results in the past with this printer and paper .
2. I have used two differnt versions of Photoshop elements. I have been useing elements 6 for many years But last week...
Good Afternoon Gentlemen
I have tried all the above suggestions But with no real improvement to my prints I am attaching a downloaded then printed and then scanned professional test print and attach it for you to see.
I think perhaps my next step should be to remove and do a really good clean...
I should have added that I am useing Photoshop elements 13
with glossy photo paper and the printer settings are
Photoshop manages colour
printer profile a is the ICC profile done for me by city ink
and the rendering is set to perceptual
I hope this is helpfull Mike
What am I missing ...
Hi 1st thank you replying ,
Re Nozzle check prints are fine.
Yes I understand that the ICC profile is just for the one paper and Ink .
I did test the other papers realising this but as the colours and general quality of print are not in question here I felt it did not matter too much ie the...
My printed photos lack vibrancy it is as if their is a VERY THIN veil in front of them I do stress this is slight but it seems to stop the photos having any punch/ vibrancy .
My set up is as folows
Cannon MX925.
useing adobe elements 13 software.
Windows 7 home premium
I am useing a...
Thank you Peter I have downloaded the manual and printed it ( Pity I could not duplex print it :-) )
I will strip it down at the weekend ( I have the grand children staying at the moment not conducive with stripping things down ) Thanks again for your help the manual shows exactly what I...
I cannot see anything causing an obstruction but the righthand end white roller
is not turning now I assume I am goint to have to strip the printer down to get this set of rollers out is there a instruction manual any where I can get to show me how to strip it down ?
Interesting Point about A5 never tried it before but it does not seem to work at all.
Re looking at the back the paper does not get that far it fails at the first set of rollers the small quarter inch dia white rollers the paper goes skew wiff dragging part of it through untill it jams
Thanks...
Hi All
My old faithful Cannon IP4600 printer has started playing up When Duplex printing . IE normal printing is fine what ever paper I use from the cassette or rear tray prints fine but today when I tried to duplex print the 1st page printed and when the paper was feeding back in it went skew...
Hi I am currently using a Canon IP 4600 which is now getting a bit long in the tooth. Before it finally gives up the ghost I want to find a replacement.
I do quite a fair bit of printing photos and need to be able to use refillable cartridges obviously for cost reasons . I have been looking...