1. Dismiss Notice
  2. Picture Of The Week (POW) Information and Submissions
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice
  3. Official PK Poll: Is there any future in refilling?
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice
  4. PK Featured Thread: The Epson RPM quality option - does it offer a benefit ?
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice

The Most reliable inkjet Printer I’ve ever had...

Discussion in 'Everything Else' started by The Hat, May 28, 2018.

  1. May 28, 2018
    The Hat

    The Hat Printer VIP Moderator

    Joined:
    Jan 18, 2010
    Messages:
    10,892
    Likes Received:
    4,848
    Trophy Points:
    393
    Location:
    Wicklow Ireland
    Printer Model:
    Canon were, BUT 3D is better..
    I don’t print all that much now, probably once every six weeks or even longer, but I do print everyday bits and pieces and for that I use the Maxify.

    It’s as close as you can get to a colour laser printer, and I can say it’s so reliable its bordering on ridiculous, it never clogs up, and I don’t bother with even a nozzle check.

    The first page out of the printer can sometimes be a bit short of a colour here or there but after it gets going it just prints page after page till it runs out of paper, that’s the only time I attend to it.

    If you’re looking for a trouble-free inkjet printer then I’d recommend the Maxify, this is the printer for the office, the home, or the garden shed, it will work anywhere, I’ve covered mine with a dust cover and have loads of rubbish piled on top of it and sometimes I forget it’s even there...

    Pick a Model that is best suited for your everyday print needs and you wont be sorry..
    I placed this post in this Section because it can be used everywhere...
     
    palombian and stratman like this.
  2. Jun 10, 2018
    palombian

    palombian Print Addict

    Joined:
    Feb 4, 2014
    Messages:
    815
    Likes Received:
    882
    Trophy Points:
    197
    Location:
    Belgium
    Printer Model:
    Pro9500II, MAXIFY MB5350
    Agree.

    I am at 5000p since last autumn.
    You need some experience with the refilling, but from then it prints and prints.
     
    The Hat likes this.

Share This Page