1. Dismiss Notice
  2. Picture Of The Week (POW) Information and Submissions
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice
  3. Official PK Poll: Is there any future in refilling?
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice
  4. PK Featured Thread: False economy to fit cheap, unbranded fuser?
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice

New member saying hello - and thanks

Discussion in 'Member Introductions' started by SooJ, Aug 5, 2018.

  1. Aug 5, 2018
    SooJ

    SooJ Printing Apprentice

    Joined:
    Aug 5, 2018
    Messages:
    2
    Likes Received:
    6
    Trophy Points:
    13
    Location:
    Aberdeenshire
    Printer Model:
    Canon MG3250
    Just signed up to show gratitude for being able to fix my Canon Pixma MG3250, such a simple fix - clean an internal part that has nothing to do with electronics. Solved the nasty alignment problem.

    Feeling relieved at being able to use my printer again.

    I'm quite hands-on and techy, but to delve into the guts of the printer with a wet wipe was not on my list of "obvious things to do"!!:weee
     
    PeterBJ, stratman and The Hat like this.
  2. Aug 5, 2018
    The Hat

    The Hat Printer VIP Moderator

    Joined:
    Jan 18, 2010
    Messages:
    10,965
    Likes Received:
    4,889
    Trophy Points:
    393
    Location:
    Wicklow Ireland
    Printer Model:
    Canon were, BUT 3D is better..
    :lol: :hugs
     

Share This Page