iP 4850 Waste Ink Pads

[TopCatToo]

Hi,
Just a bit of feedback...........

My iP 4850 recently showed a error indicating the wast ink absorber was full.
Following the advice on this forum, I successfully dismantled the printer, cleaned, dried and replaced the pads and reassembled the printer.
I downloaded the service tool, got it into service mode and reset the absorber value.

And it works!!!

My wife says I sounded really surprised.

Many thanks to all concerned.
Steve

 

[stratman]

Fantastic job! You have boldly gone where few have dared travel. As it is said, no risk no reward. May you be rewarded with years of faithful printer service.

Did you take pictures along the way to help you rebuild the printer? If so, I am sure many would enjoy seeing some of them. You know, porn for printer addicts.