1. Dismiss Notice
  2. Picture Of The Week (POW) Information and Submissions
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice
  3. Official PK Poll: Is there any future in refilling?
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice
  4. PK Featured Thread: A Real Cool Upgrade to Improve your 3D Printing...
    CLICK HERE!
    (if you are logged in, this notice can be dismissed using the "x" to the top right of the notice)

    Dismiss Notice

Hello from Shropshire

Discussion in 'Member Introductions' started by PeterG, Oct 7, 2018.

  1. Oct 7, 2018
    PeterG

    PeterG Printing Apprentice

    Joined:
    Oct 7, 2018
    Messages:
    6
    Likes Received:
    2
    Trophy Points:
    10
    Printer Model:
    Prixma Pro 1
    Hi,

    I've had my Cannon Pixma Pro 1 for about 4 years and love it, just not the cost of the genuine inks, so will be looking for some recommendations on OEM units. I've also just picked up a second Pro 1 with a little fault and hope you can help me identify the bit that's broken so I can fix it.

    I've also got a HP LaserJet 5Si, can't beat the old workhorse, and my wife has a couple of different printers for sublimation.

    I've also had my Wanhao i3 Mk2 for about 2 years, happy to discuss that and different aspects of 3d printing too.

    I'm looking forward to joining in the forum.

    Thanks.
    Peter.
     
    The Hat likes this.
  2. Oct 7, 2018
    The Hat

    The Hat Printer VIP Moderator

    Joined:
    Jan 18, 2010
    Messages:
    10,791
    Likes Received:
    4,787
    Trophy Points:
    393
    Location:
    Wicklow Ireland
    Printer Model:
    Canon were, BUT 3D is better..
    @PeterG, Sounds like you’ll fit in here nicely, with your interest in many different types of printer.. :)
     

Share This Page