Hi,
I am looking for a new print head for MP970. Some sites say it's QY6-0062 while other sites categorically stated that it's for
MP950 MP960 IP7500 IP7600, and not MP970. Does anybody have a correct info and any recommendation where it's best to get it from?
Thank you in advance.
Kefp
I have 2 CLI8 resetters, the original red one (bought it when the price was sky high) and a blue one. Both seem to have a hard time resetting a cartridge nowadays. It takes a lot of mucking around to get a cart reset, unlike when they 1st arrived. I have changed the batteries in both cases to...
Hi, my 1st clog that was not successfully remedied by a cleaning cycle.
Initially after a deep cleaning cycle, the printer worked fine but by the following day it happened all over again. I have been following some threads but not quite sure if the next step should be dripping windex into the...
My MP970 has been printing photos well with prism profile and Qimage. But suddenly the photo turned extremely green (not just a slight cast). After reprofiling the printer, there's still a slight green cast. Does anybody know if the printer/Qimage has a setting that I may have accidentally...
I have MP780 and a new IP4500.
The IP4500 still has the original canon ink. The MP780 is refilled with ink from inksupply.com.
Paper used are Kirkland and Ilford papers from Costco. Printing software is normally Canon EasyPhotoprint. I like to print 4 snapshots on an 8x11. My camera is Canon...
I just acquired an IP4500 and a MP970. Was wondering if the MIS bulk ink that I used for MP780 is still compatible with IP4500 and MP970?
Checking the Inksupplydotcom site, it offers different codes - CANS800 vs CANCLI8.
Thanks
I was wondering if anybody has any experience with the above ie - when looking a photo printed on a glossy photo paper at an angle, the dark area (black hair etc) appears matted in comparison to other areas. It's a little bothersome.
I don't believe I have accidentally mixed up the black...
Hi - A great forum!
I was wondering if anybody has any experience with prints being scratched/marked by the roller mechanism? It looks as though it's from the top part of the mechanism-above the print. It runs across the entire page as a straight line, much like knife cut. The thicker the...