ScanDeltaE  ver 0.93  

Compare Delta E between two measurement sets (.mxf or .ti3, any mix)
====================================================================

WHAT IT DOES
  Takes two measurements of the same chart and shows, patch by patch, how
  far apart they are (Delta E 2000). Patches above the threshold are flagged
  so you know which ones to re-measure in i1Profiler.


HOW TO USE
  1. Select the two files (.mxf and/or .ti3) and drag them onto
     ScanDeltaE.bat. The first file is the reference (File A).
  2. Dropped only one file? You will be asked for the second.
     Double-clicked the .bat? You will be asked for both
     (drag each file into the window and press Enter).
  3. Read the results. The window stays open until you press a key.

  Tip: Windows decides the order of dropped files by which one you grab.
  The file you click on to start dragging usually becomes File A.


LAYOUT MAP: 
The chart drawn as a grid, each cell showing patch name and dE00. 
Failures are RED blocks, "watch" values are yellow.
- Rows are numbered 1, 2, 3 ...; columns are lettered A, B, C ...
- Z, then AA, AB, AC ... (as in i1Profiler / ArgyllCMS patch names).



note: Currently the THRESHOLD is set to 0.5 (dE00) for demonstration purpose.