Generate target ti1 file with

targen.exe -v -d2 -g 24 -f 384 A5384

where -g is the number of grey patches and -f the total number.
A5384 is the base file name 

Generate a target tif and ti2 file with 

printtarg.exe -v -i 22 -p148.492x210 -a1 -T360 -m3 -y"0-9,0-9" A5384

where -p is the sheet dimensions in mm. -m is the reqired print margins in mm. 
-a is the patch scaling factor. 1 for 8mm patches and 1.25 for 10mm patches.
A5384 is the base file name. 

The tif file target must be printed with an accurate 360 DPI scaling and no 
colour management. Information on the top and sides of the target is not essential 
and could be cropped if necessary.  

ColorQC 2 measurement parameters must be

L* a* b* 400nm through 700nm

Light/angle setting D50 and 2 degrees

Carefully measure the patches column by column starting with patch A00. 

Select all the measured rows and file save as .csv with the same base file name as
the .ti2 file. The csv must be comma separated and use decimal point in numbers. 
If your computer locale messes that up you will have to fix it somehow. 

Run the awk script genti3.awk to generate a ti3 file with 

gawk -f genti3.awk A5384.ti2 > A5384.ti3

Generate a colour profile with 

colprof -v -qh -bh -c mt -d pp -i D50 A5384

where A5384 is the base file name.