Pixma Pro9500 Mark II - B200 Error

nasabuzi

Printing Apprentice
Joined
Dec 14, 2011
Messages
7
Reaction score
2
Points
14
Twice over the last couple months I had the B200 error come up when trying to print and I would get it to go right away with turning it off and unplugging for a little bit like I had read about online.

Well after printing some stuff two days ago and it working completely fine I go to print yesterday and that damn pesky B200 error is back. Well tried unplugging it and letting it sit for a little bit a couple times now and the power button and resume button just flash back and forth. I can't get the printer head to move at all when lifting the lid.

Any ideas of what this might be besides a possible new printer head? Not really sure how to get to the printer head even now since I can't get it to move.
 

palombian

Printer Master
Joined
Feb 4, 2014
Messages
1,869
Reaction score
2,243
Points
297
Location
Belgium
Printer Model
PRO10,PRO9500II,MB5150,MG8250
Happy to hear about a temporary going away B200 error, but IMO you should buy a new head.
Too bad, that's the cost of printing.
The positive is that compared to low cost consumer printers the head costs much less than a new printer (or even a second hand) and in fact about the same as ONE set of (OEM) cartridges (or 5 3th party refills).

Hope you didn't burn the logic board.
 
Top